background image

USE OF THE CHRONOGRAPH 

The chronograph function can only be used when the 
crown is in position 

1

PUSH-BUTTON 

START/STOP 

PUSH-BUTTON 

ZERO RESET/ 
INTERMEDIATE TIMING 

START 

Press push-button 

to activate the seconds hand of 

the chronograph. If the timed activity lasts longer than 
60 seconds, the time elapsed will next appear on the 
minutes counter and after a further 30 minutes on the 
1/10 second counter, which has by now become an 
hours counter. 

NOTICE 

Disposal of a watch by non-compliant methods 
may cause harm to the environment and is heav­
ily fined according to the regulations 

established by each one of the EU member countries in 
application of the Directive on Waste Electrical and 
Electronic Equipment (Directive 2002/96/EC WEEE). Should 
you need to dispose of an old watch, please set it aside for 
separate waste collection or give it to a retailer when pur­
chasing a new watch. 
RAYMOND WEIL and its approved dealers are at your 
disposal to provide you with additional information on 
the subject. 

STOP 

Press push-button 

a second time to stop the chronograph 

and obtain the time that has elapsed (in minutes, seconds 
and 1/10s of a second; or in hours, minutes and seconds 
after 30 minutes). By pressing push-button 

again, timing 

restarts immediately. Thus you can measure several 
consecutive time-durations. 

RESETTING TO ZERO 

Press push-button 

in order to reset all the chronograph 

counters to zero. Your watch is now ready to start 
timing again. Resetting to zero is only possible once 
the chronograph has been stopped. 

INTERMEDIATE TIMING 

Press push-button 

to start the chronograph. Then press 

push-button 

to obtain the first intermediate time. While 

the chronograph is stopped, the activity continues to be 
timed. Press push-button 

again to allow the chronograph 

hands to make up the time elapsed since the first stop. 
Press push-button 

to stop the chronograph and read 

off the total time. Press push-button 

to reset to zero. 

If one or several of the chronograph hands are not in 
their exact starting position, it is necessary to adjust 
them. Therefore pull the crown out to position 

3

. Press 

push-buttons 

and 

simultaneously for at least 2 seconds. 

The chronograph seconds hand then rotates through 
360° and the correction mode is activated. Next, press 
push-button 

to adjust the seconds hand (a short push 

to adjust step by step, or a long push for continuous 
adjustment). Then press push-button 

to pass on to 

the following hands (1/10 second, then minutes) and 
adjust them as previously explained. Push the crown 
back in to position 

when adjustment is completed. 

RECOMMENDATIONS 

Your RAYMOND WEIL watch is powered by a battery 
with an average life of approximately 36 months, which 
can vary according to the frequency of chronograph usage. 
In order to make the battery last longer, pull the crown out 
to position 

whenever you do not intend to wear your 

watch for a while. 

Once exhausted, the battery should be replaced 
without delay, in order to avoid any risk of damage 
to the movement. 

Please have your watch battery changed only by 
an approved RAYMOND WEIL dealer. 

2/2 

Reviews: