Chapter 1: Operation
15
•
Set whether headings are displayed in true or magnetic form.
•
Set the voltage at which a battery alarm will occur.
•
Enable/disable individual local alarms.
•
Set the date format.
•
Set the time format.
•
Set the instrument time to local time.
•
Select the units in which temperature, speed, trip, depth and wind speed
from NMEA are displayed.
•
Select the function of the display
NMEA OUT
connector. This is either
•
A remote alarm output for the Auxiliary Alarm (NMEA OFF).
or
•
NMEA output signals.
•
Enable/disable individual remote alarms.
•
Enable/disable the pilot pop up display.
•
Configure the instrument to display specific pages.
Procedure
To carry out the required setup procedure:
1. Hold down the
and
buttons for approximately 2 seconds so that
the User calibration entry screen is displayed.
Note:
The User calibration entry screen will time out to the main display
after 7 seconds.
2. Press the
button to enter User calibration.
3. Referring to the
User calibration
diagram below, use the
button to
cycle to the required screen, then set the required values as described
below.
Favorite page rollover
Use the
track
or
reset
button to set the required Favorite page rollover
period, from 0.5 s to 20 s. Press the
track
button to reduce the rollover period
and the
reset
button to increase it.
If you want to be able to select Favorite pages manually as for other chapters,
use the
track
button to reduce the value of the rollover until
OFF
is displayed.
81226_1.book Page 15 Wednesday, November 19, 2003 9:53 AM
