Chapter 4: Installing the SportPilot
29
4
In
st
all
in
g th
e S
po
rtP
ilo
t
Note: You will plug the moulded connector into the
RUDDER REF
socket when installing the SportPilot (see page 45).
Post installation checks
When you have connected the sensor to your SportPilot, pressurize
the steering system (if required).
Note: Contact your steering gear manufacture for advice on this step.
Follow their instructions for re-pressurizing the hydraulic pressure.
Rotary rudder position sensor – installation
(hydraulic inboard steering systems)
Note: Hydraulic inboard steering systems MUST be fitted with a
linear rudder position sensor.
The rotary rudder position sensor can be used on hydraulic inboard
steering systems to transmit the precise position of the boat’s steering
to the SportPilot. Depending on your engine installation, you can
mount the sensor to the steering arm, or to the tie bar.
D1544-2
RUDDER REF cable
Scotchlock
connector
Linear rudder position sensor cable
140 mm (5.5 in)
187 mm (7.35 in)
70 mm (2.75 in)
60
mm
(2.4
in)
D5386-1
Summary of Contents for SportPilot
