Raymarine SL72, Owner'S Handbook Manual

Page: 194 / 243

Chapter 8: Installation 8-27
Ra
da
r S
ys
tem
C
h
ecks a
nd
Ad
ju
st
m
en
ts
➤
To adjust the radar to eliminate the alignment error:
1. If a visual relative bearing of a target has been determined, as in 2.1 above,
set an EBL to this relative bearing.
2. Press the
MENU
key to display the setup soft keys and select
RADAR SET UP
.
Figure 8-15: Radar Set Up Menu
3. Use the trackpad to move the selection bar on the Radar Set Up Menu to
BEARING ALIGNMENT .
4. Use the soft keys to adjust the Bearing Alignment slider and to rotate the
radar picture. As soon as you start the adjustment, the menu is cleared so
that the rotation of the picture can be seen. The keys can pressed and held,
to rotate the picture quickly, rather than in single steps.
5. Rotate the picture to place the target under the EBL, or Heading Marker,
depending on the method used to obtain the correct relative bearing.
6. When the bearing alignment error has been eliminated press
ENTER
to re-
display the Radar Set Up menu.
7. Press
ENTER
again to return to the set up soft keys, then press
CLEAR
to
return to the normal radar screen.
8. After adjusting the radar, always check the bearing alignment at the next
opportunity. Usually the bow alignment to target is the most convenient
method (see
If the vessel is under way (in reasonably calm conditions): on
page 8-26 ).
Display Timing Adjustment
The display timing can be affected by the length of the cable used to connect
the scanner to the display unit. This in turn affects the short range accuracy
shown on the display. If you have extended (or reduced) your inter-unit cable,
D3649-2
RADAR SET UP MENU
EBL DISPLAY EBL DISPLAY
TIMED TRANSMIT TIMED TRANSMIT
TRANSMIT PERIOD TRANSMIT PERIOD
STANDBY PERIOD STANDBY PERIOD
DEFAULT MARK SYMBOL DEFAULT MARK SYMBOL
MARK DISPLAY MARK DISPLAY
CLEAR MARKS CLEAR MARKS
CUSTOM SCALE CUSTOM SCALE
BEARING ALIGNMENT BEARING ALIGNMENT
RELATIVE RELATIVE
OFF OFF
20 SCANS 20 SCANS
10 MINS 10 MINS
x
OFF OFF
OFF OFF