Raymarine RVM-100, Installation Instructions Manual

Page: 28 / 56

4. Using a pozi-drive screw driver and the screws provided, secure the
transom mount bracket using the 2 adjustment slots.
Note:
The third screw is not used until the transducer has been successfully
tested.
Mounting the transducer
The transducer is mounted to the mounting bracket using the supplied nut
and bolt.
Important:
• Only perform the installation with your vessel out of the water.
• Do NOT lift or suspend the transducer using its cable.
• Do NOT overtighten the bolt. Overtightening may cause damage to
the transducer.
Note:
The screw located on top of the transducer is used when connecting the
transducer to a mounting adaptor such as the Step mount bracket (A80479).
You do not need to adjust this screw for transom mount installations.
1. Ensure that the plastic chock (marked ‘ A ’ in the illustration) is positioned
in front of the transducer cable. If it is not, push the chock into the correct
position, aligning the hole in the chock with the holes in the transducer.
2. Position the transducer between the arms of the mounting bracket.
3. Align the hole in the transducer with the holes in the mounting bracket.
4. Slide the mounting bolt through the holes.
5. Screw the flanged nylock nut onto the end of the mounting bolt.
28