Raymarine Quantum, Installation Instructions Manual

Page: 27 / 52

Grounding
Ensure that you observe the separate grounding
advice provided in the product’s documentation.
More information
Raymarine recommends that best practice is
observed in all vessel electrical installations, as
detailed in the following standards:
• BMEA Code of Practice for Electrical and
Electronic Installations in Boats
• NMEA 0400 Installation Standard
• ABYC E-11 AC & DC Electrical Systems on Boats
• ABYC A-31 Battery chargers and Inverters
• ABYC TE-4 Lightning Protection
Warning: Grounding not required
This product is fully insulated and does
NOT require separate grounding.
4.4 Network connection
The scanner must be connected to a compatible
Raymarine multifunction display, either via Wi-Fi,
or via a physical RayNet cable connection. Once
connected, the multifunction display can show Radar
echo data.
Wired (RayNet) multifunction display connection
Scanner connected to a multifunction display using a
RayNet cable.
D13408-2
12 / 24 V
1
2
3
Item Description
1 Quantum™ Radome (for clarity, only the
connections area of the underside of the unit is
shown here).
2 Connector panel of compatible Raymarine
multifunction display.
3 RayNet data cable.
Wi-Fi multifunction display connection
Scanner connected to a multifunction display using
Wi-Fi.
1
2
3
12 / 24 V
D13410-2
Item Description
1 Compatible Raymarine multifunction display with
Wi-Fi capability.
2 Quantum™ Radome.
3 Wi-Fi datalink.
Refer to the Switch on and initial setup section, and
to your MFD documentation for further information
about setting up the Wi-Fi connection between your
MFD and the Quantum™ scanner.
Cables and connections
27