Raymarine i40, Installation And Operation Instructions Manual, Page: 36 / 68

7.1 Pages
The pages available depend on the display variant and are shown
in the table below:
i40 Bidata i40 Depth i40 Speed i40 Wind
Current depth /
speed Current depth Current speed Apparent wind
Maximum speed* Minimum depth* Maximum speed*
True wind
Average speed* Shallow alarm* Average speed* High wind speed
alarm*
Log* Deep alarm* Log*
Trip* Shallow anchor
alarm* Trip*
Water
temperature Deep anchor
alarm* Water
temperature
Minimum depth* Depth offset*
Shallow alarm*
Deep alarm*
Shallow anchor
alarm*
Deep anchor
alarm*
Depth offset*
Note: *These pages are temporary pages and will revert to the
previous permanent page after 5 seconds.
Changing pages
During normal operation:
1. Press the Up or Down buttons to cycle through the available
pages.
7.2 i40 Bidata operation
When connected to the relevant transducer(s) your i40 Bidata
instrument:
• Provides speed information (current, maximum and average), in
either knots (KTS), miles per hour (MPH) or kilometers per hour
(KPH).
• Provides log and trip information. These are given in either
nautical miles (NM), statute miles (M) or kilometers (KM).
• Provides water temperature information. This is given in either
degrees celsius (ºC) or degrees fahrenheit (ºF).
• Provides depth information in either feet (FT), metres (M) or
fathoms (FA).
• Records the minimum depth encountered during the period the
unit is switched on. This can be reset at any time.
• Enables you to define alarm thresholds for shallow alarm, deep
alarm, shallow anchor alarm and deep anchor alarm.
• Enables you to see what offset is applied to the depth reading.
Note: The required speed, distance, depth and water temperature
units are selected during User calibration.
It should be noted that:
• Up / Down depth-trend arrows are displayed, if the seabed is
rising or falling at a significant rate.
• The log screen shows the total distance covered by the vessel
since the unit was fitted.
• Minimum depth, maximum speed, average speed and trip reading
are reset to zero at power up.
i40 Bidata Display
The display is split into upper and lower data areas, each of which
shows either depth or speed information, depending on user
selection.
The Current speed , Current depth and Current water
temperature pages are permanent pages, all other pages are
temporary and will time-out after 5 seconds, to the last permanent
page displayed.
Switching the depth and speed position
D12510-1
1. Press the Action button to switch speed and depth positions
on the display.
36 i40