Last revised: April 2019
10
Battery Monitor:
1
–
The Xantrex LinkPRO battery monitor is located below the starboard settee. It is
used to check usage and state of the house battery bank (main). Scroll through the
values by pressing the arrow keys. It shows the battery voltage, current draw in amps,
amp hours used, and percent of amp hours used. Do not let the batteries go below 11.8
volts, 150 Ah used, or 50% or the bank will be damaged. The starter battery voltage only
can also be displayed. It should normally stay over 12.6 volts.
2
–
When the engine is running and the house bank charging, the monitor will indicate
the amps the alternator is supplying to the bank (40 to 50 amps initially, then less and
less as the batteries charge). The voltage can be as high as 14.6 during charge.
Inverter
There is a portable inverter for charging phones, computers, or cameras above the chart
table. It will
not
run the microwave, hair dryers, or the heater. Plug it in to the 12 volt
“cigarette” outlet on the 12 volt panel or in either cabin, turn on the switch, and plug in
your AC plug. There are also two USB convertors in the navigation table that plug into
the 12 volt outlets for easier charging of phones.
AC Power Outlets
There are AC power outlets throughout the boat. These only supply power when
plugged into shore power. Turn on the outlet switch on the AC panel. They are all on a
CFGI circuit
for safety. If the CFGI trips, the reset button in on the outlet to the left of
the VHF and Fusion stereo.
5.
Berths and Bedding
- For added comfort in the aft and forward cabins
, we have added 2 inches of “memory
foam” topper to the boat mattress, with a wrap
-around mattress pad to secure it all.
- Each berth has a comforter. SJS provides 2 sheets and pillow cases for each berth.
- Two adults can also sleep on the convertible dinette. To convert the dinette, pull up on
the table to lift it off of the two aluminum tube supports. Remove the aluminum tube
supports and carefully place the table onto the seats. There is a sliding latch under the
forward seat to secure the table. Place the filler cushion; it is stored up against the wall
of the forward cabin. This is an unusually long berth.
