Raymarine eci-100, Installation Instructions Manual

Page: 42 / 58

LED indications
This product contains 2 diagnostic LEDs, one for the SeaTalk ng connection and one for the engine CAN bus
connection. The LEDs for this product flash (blink) in set sequences which provides information on the
current status of the unit for diagnostics and troubleshooting purposes.
LED color SeaTalk ng LED code
Engine CAN bus LED
code
State User action
Red
Powering up None (normal power up takes
approximately 6 seconds.)
Green
15s 15s
Normal operation None
Green
15s
DeviceNet powered
on, SeaTalk
ng
powered off
Power up SeaTalk ng network.
Red
9 s
9 s
Network connected
but no traffic (no
message received in
more than 5 seconds.
Red
SeaTalk ng powered
on, DeviceNet Off.
Red
3 s
3 s
General error (Device
connected wrong way
round Swap over SeaTalk ng and DeviceNet
connections
Red
Software download in
progress (longer than
6 seconds.) Wait for download to complete —
Multifunction display will indicate
when software download is
completed.
Note: If any other LED sequence other than described above is seen and persists please contact
Raymarine technical support.
Resetting the ECI-100
A specialist tool is required to reset the ECI-100,
contact Raymarine Product Support for further
information.
Your ECI-100 will need resetting if it has previously
been used on a different engine type.
42
ECI–100