5.2 Mounting
Pre-mounting check
The product is designed to be surface mounted. Before
mounting the unit, ensure you have:
• Selected a suitable location.
• Identified the cable connections and route that the cables will
take.
• Detached the front bezel.
• Remove the keypad mat.
Mounting diagram
D12379-1
Mounting instructions
1. Check the selected location for the unit, a clear, flat area with
suitable clearance behind the panel is required.
2. Fix the mounting template supplied with the product, to the
selected location, using masking or self adhesive tape.
3. If possible use an appropriate size hole cutting saw and cut
out the centre hole cut out area as indicated on the mounting
template, or
4. Using a suitable hole cutting saw, make pilot holes in each
corner of the cut out area and using a jigsaw cut along the
inside edge of the cut out line.
5. Ensure that the unit fits into the removed area and then file
around the cut edge until smooth.
6. Drill any required holes as indicated on the mounting
template for the securing screws.
7. Connect the relevant cables to the unit.
8. Peel the backing off of the supplied gasket and place the
adhesive side of the gasket onto the display unit and press
firmly onto the flange.
9. Slide the unit into place and secure using the screws
provided.
10. Refit keypad mat and front bezel.
Note:
Drill, tap size and tightening torques are dependant
upon the material type and thickness of the mounting surface.
Note:
The supplied gasket provides a seal between the unit
and a suitably flat and stiff mounting surface or binnacle.
The gasket should be used in all installations. It may also
be necessary to use a marine-grade sealant if the mounting
surface or binnacle is not entirely flat and stiff or has a rough
surface finish.
5.3 Front bezel
Removing the front bezel
D
12372-1
1
2
3
4
Note:
Use care when removing the bezel. Do not use any
tools to lever the bezel, doing so may cause damage.
1. Using your fingers pull the bezel away from the unit at the
top and side, as shown in 2.
The bezel will start to come away from the unit at the top
and side.
2. Now pull the bezel away from the unit on the opposite side,
as shown in 3.
The bezel will now come free from the unit, as shown in 4.
Location and mounting
27
Summary of Contents for E70061
