62
DSM300 Installation Manual
Status LED
The LED on the connector panel provides valuable information on the status of
your DSM300. The LED blinks green while the module is operating normally. If the
unit detects a problem, the LED blinks amber to indicate a warning or red for an
error. The number of times the LED blinks is a code representing the nature of the
problem. For multiple warnings/errors, the codes are given in sequence with a 1.5
second pause between strings.
The following table shows the various LED status codes and their meanings.
1
After 30 seconds of no network activity, the DSM300 enters Standby mode: No sonar
pings are emitted and no warnings are output on the LED. Instead, the LED blinks green
once every 10 seconds.
For example, if the Transducer Sense fails and the network is not detected, the LED blinks
amber once, pauses 1.5 secs, blinks amber twice 0.5 secs apart, pauses 1.5 secs, and then
repeats the sequence until the problems are resolved or up to 10 minutes elapse.
Sounder temperature
readings are wrong
1. If necessary, adjust the TEMP CALIBRATE parameter.
2. If receiving SeaTalk temperature, unplug the SeaTalk con-
nector from the display.
Sonar display is unreli-
able at high boat speeds
1. Turbulence around the transducer may be confusing the
unit.
Table 3-2: Status LED Warning Indications
Color
No of
blinks
Meaning
Cleared
every 10 min
W
Amber
1
Transducer Sense Failure
A
2
Network not detected
1
R
3
High Temperature Warning
✓
N
4
Reserved
I
5
Reserved
N
6
Reserved
G
7
Reserved
S
8
Watchdog Timeout Reboot
✓
Table 3-1: Common Sounder Problems
Problem
Correction
