Chapter 1: Operation
3
Silencing the shallow alarms
Press
speed
or
depth
to silence the audible alarm for a period of two
minutes. If, after 2 minutes, the water depth is still below the alarm
setting, the alarm will be activated again.
Note:
When the audible alarm is silenced the alarm icon continues to
flash.
Turning shallow alarm ON and OFF
1.
Ensure the shallow alarm screen is displayed.
2.
Press
depth
and
speed
together momentarily to enter CAL
mode.
3.
Press
depth
to switch the alarm ON or OFF.
4.
Press
depth
and
speed
together for 2 seconds to exit CAL mode.
Offset
This is the distance (feet or metres) from the Biducer to the bottom of
the hull or to the waterline, which can be a positive (
+
) or negative (
-
)
value.
Default display
The depth display will always default back to water depth 8 seconds
after the last key press.
Loss of signal
If there are no depth echoes for 10 seconds, the feet/metres legend
flashes and the last recorded depth is displayed until a new echo is
received.
075_4c01.p65
11/04/01, 11:27
3
Summary of Contents for Autohelm ST30 Bidata
