Wuhan Raycus Fiber Laser Technologies Co., Ltd
User Guide RFL-QCW300/3000
19
Figure 14 RS-232
Table 5 RS-232 pin definition
Pin
Description
2
RX
3
TX
5
GND
Others
NC
Figure 15 Wire of RS-232 serial
4.5
Operation Modes
There are three main modes of laser operation:
CW
,
PULSE
and
Wave
. The main
differences between CW mode, PULSE mode and Wave mode are as follows:
a)
In PULSE mode the maximum peak power (3000W) is considerably higher than in CW
(300W).
b)
In PULSE mode, the maximum pulse duration and the maximum duty cycle are limited
to certain values (refer to Figure 16 PULSE mode operational range).
c)
In CW mode, the maximum pulse duration and duty cycle are not applicable.
d)
In Wave mode, the control system can store at most 100 waveforms and each of the
waveform is made up by at most 200 points, representing a power curve. The output
power for the laser varies with the power curve.
受
控
武汉锐科
