Wuhan Raycus Fiber Laser Technologies Co., Ltd.
User Guide of RFL-C30000XZ
16
our personnel and obtain relevant qualification before they can carry out the above
operation. If the operation mode is improper, the output optical cable will be
irreversibly damaged.
After the cleanliness is ensured, load the B type end cap. During the installation process,
when screwing it to the bottom, there will be resistance, which is a Normal phenomenon. It is
necessary to ensure that there is no gap between the end cap and the main sleeve, then check
the smooth surface finish and cleanliness of the end cap, as shown in the figure. Then
connect the optical cable output head with the cutting head (or welding head) under the
condition of loading type B end cap. The operation needs to ensure the cleanliness of the
internal and external surfaces of the cutting head (or welding head) connector.
Note: connecting with cutting head (welding head) needs to be carried out in a clean
workbench; it is necessary to check the cleanliness and finish of related components for
the cutting head (or welding head)
Keep the corresponding accessories as shown in figure 9 to facilitate the reoperation of the
laser or output optical cable.
Note: during each transfer, the optical cable must be loaded with type A end cap. Each
time the output optical cable is unloaded from the cutting head and needs to be
transferred, the B-type end cover must be replaced by A-type end cover, and the white
anti-dust cover must be covered, and finally put into the black packaging box for
transfer.
Figure 9 customers need to keep the following accessories: black protective box
、
white anti-dust cap
、
type-A end cap.
