RSCAC-9556 Series
INSTALL INSTRUCTIONS
www.raycap.com
©Raycap • All rights reserved
(320-1392) Rev.A
Page 2 of 10
1.0
Copyright
©
Raycap, Inc. 2019 - All Rights Reserved
1.1
Disclaimer
The information in this document is subject to change without notice and describes only the product
defined in the introduction of this documentation. This documentation is intended for the use of
Raycap customers only for the purposes of the agreement under which the document is submitted,
and no part may be used, reproduced, modified or transmitted in any form or means without the prior
written permission of Raycap. The documentation has been prepared to be used by professional
and properly trained personnel, and the customer assumes full responsibility when using it. Raycap
welcomes customer comments as part of the process of continuous development and improvement
of the documentation.
Raycap has made all reasonable efforts to ensure that the instructions contained in this document
are adequate and free of material errors and omissions. Raycap will, if deemed necessary, explain
issues which may not be covered by this document.
The contents of this document are subject to revision without notice due to continued progress in
methodology, design and manufacturing. Raycap shall have no liability for any error damage of any
kind resulting from the use of this document.
1.2
Warnings
Please read this manual prior to use to become familiar with the product’s numerous features and
operating procedures. To maintain the maximum degree of safety, follow the sequences as outlined.
Before using the product, read all instructions and cautionary markings on the product and on any
equipment connected to the product.
CAUTION – Unless otherwise noted, product usage that is not recommended or sold by the product
manufacturer can result in risk of fire, electric shock, or injury to persons.
CAUTION – Do not operate the product if it has been damaged in any way. Return damaged
products to Raycap for repair or replacement.
CAUTION – Do not disassemble the product. Incorrect re-assembling can cause the risk of electrical
shock or fire.
WARNING – Disconnect or disable the AC power source to the product prior to beginning its
installation. Ensure that the AC power source to the product remains de-energized until the
completion of the installation and after all connections have been verified to be correctly configured.
For conditions other than those described above, please phone a Raycap Account Representative at
(208) 777-1166, (800) 890-2569 or www.raycap.com
Thank you for choosing quality products from Raycap
QUESTIONS? VISIT WWW.TALLEYCOM.COM OR CONTACT TALLEY AT 800.949. 7079 OR [email protected] TODAY.
