30
The method of connection to the mains electricity supply
must facilitate complete electrical isolation of the appliance,
by a multi-pole switch, having a contact separation of at least
3 mm on all poles.
The isolator should not be positioned immediately above the
cooker, but must be fitted within 2 metres of the appliance.
The isolator maybe separate from the connection point.
The mains connection point must be accessible within the
areas shown in
for cable routing options.
Induction Hob
An additional,
separate single phase power supply
is
required. 230V ~ 50Hz, 13amp fused three pin plug electrical
supply.
16. Electrical connection
Fig. 16.1
n
WARNING: This appliance must be earthed.
n
This appliance is designed for the voltage stated on
the rating plate, which is situated behind the plinth
cover.
n
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified person to avoid a hazard.
For the cooker
For the cooker one 13 AMP 230V 50 Hz fused electrical supply
are required adjacent to the appliance. External wiring to
the unit must be installed using the mains cable provided,
in accordance with the current wiring regulations and any
local regulations which apply. If the cable is shortened, new
ferrules must be fitted to the stripped conductors.
WORKTOP
WORKTOP
0.9
metre
s
1.8
me
tre
s
450m
mM
AX
Cable point for 3m long 13A cable supplying induction hob.
Cable point for 3m long 13A cable supplying main cooker.
THE MAINS SUPPLY MUST BE WITHIN THE ZONES SHOWN. IF A RECESSED
COOKER CONNECTIONIS TO BE USED BEHIND THE APPLIANCE WITHIN THE
HATCHED AREA ALLOW A 5mm GAP AT THE REAR OF THE APPLIANCE.
THE MAINS SUPPLY MUST BE WITHIN THE ZONES SHOWN. IF A RECESSED
COOKER CONNECTION IS TO BE USED BEHIND THE APPLIANCE WITHIN
THE HATCHED AREA ALLOW A 5mm GAP AT REAR OF APPLIANCE.
Cable point for 3m long 13A cable supplying the two hotplates
Cable point for 3m long 13A cable supplying main cooker.
WORKTOP
0.9 metr
es
450mm M
AX
1.8 metr
es
WORKTOP
DESN 517950
