6
Introduction to the Timer
If the 'cook'
symbol is not
displayed the
program has either:
Ended and the oven
is non-operational or,
The oven is being
contolled by an
automatic program
that has not started.
You can use the clock (Fig. 4) to turn the oven on and
off. The clock must be set to the time of day before the
oven will work .
The table below describes the symbols shown on the
digital display.
Fig. 4
DESN 517079
Symbol
Function
Notes
[AUTO]
[dot]
Minute Minder is on
Oven can be
operated
Oven is being
controlled in semi-
automatic or
automatic mode.
Flashes during
setting the time of
day.
• Press and hold both the and buttons down
(Fig. 6). Now press the [+] button (
or {-] button
) until
the correct time shows.
Setting the Time of Day
When the cooker is first connected to the mains, or if
there has been a prolonged power interruption, the clock
display flashes [ 0.00 ] and [AUTO].
During the time setting process the centre dot will flash.
When the process is complete the dot will stop flashing
and the
symbol will be displayed.
The time of day can be set in two ways:
• Press and hold the button. Now press the [+] or [-]
buttons to increase or decrease the time (Fig. 5).
Holding the [+] or [-] buttons for more than 2 seconds
will advance/decrease the set time quickly. Release
the buttons to set the time of day.
Fig. 5
DESN 517066
Do not forget that it is a 24-hour clock .
If you need to reset the clock/cooker, turn off the power
and wait several minutes, then start again.
Fig. 6
DESN 517067
