C
HAPTER
4
26
Unverferth NutriMax™ Applicator ISO Steerable Hitch Installation & Operation Manual
• AUTO MODE- When the Steerable Hitch node is in AUTO MODE, the implement will compensate for turns
made by the tractor to maintain track alignment between the tractor and the implement. Once AUTO mode is
enabled, the system will default to it when the master switch is toggled. To enable AUTO MODE:
1. Toggle the master switch ON.
2. Push the AUTO/TRANSPORT switch on the switchbox to AUTO.
• CENTER MODE- When the Steerable Hitch node is in CENTER MODE, the implement will align itself as closely
as possible to the calibrated zero position. To enable CENTER MODE:.
1. Toggle the master switch ON.
2. Push the AUTO/TRANSPORT switch on the switchbox to TRANSPORT.
IMPORTANT:
Once CENTER mode is used to shift the tongue, the steerable hitch system will maintain that tongue
position. To resume AUTO mode, toggle the master switch OFF and then On again.
• BUMP MODE- When the Steerable Hitch node is in BUMP mode, the implement will move a fixed number of
degrees. The bump value is set in the Home Screen under Bump Rate. To enable BUMP MODE:
1. Toggle the master switch ON.
2. Push the LEFT/RIGHT switch on the switchbox to the desired direction.
NOTE:
A single tap will result in a shift at that selected bump rate. Press the switch multiple times to repeat
the bump.
IMPORTANT:
Once BUMP mode is used to shift the tongue, the steerable hitch system will maintain the tongue position.
To resume, AUTO mode, toggle the master switch OFF and then ON again or select AUTO mode.
• MIN MODE- When the Steerable Hitch node is in MIN MODE, the implement is manually driven to the left or
the right at the preset minimum pulse width (refer to the Manual Control Screen). To enable MIN MODE:
1. Navigate to the Manual Control Screen.
2. Select Engage Min.
3. Manually drive the implement to the left or right by pushing the LEFT/RIGHT switch on the switchbox in the
desired direction (L or R).
NOTE:
The system will continue to drive the coils at the minimum pulse width while the LEFT/RIGHT switch is
held.
• MAX MODE- When the Steerable Hitch node is in MAX MODE, the implement is manually driven to the left or
the right at the preset maximum pulse width (refer to the Manual Control Screen). To enable MAX MODE:
1. Toggle the master switch ON.
2. Navigate to the Manual Control Screen.
3. Select Engage Max.
4. Manually drive the implement to the left or right by pushing the LEFT/RIGHT switch on the switchbox in the
desired direction (L or R).
NOTE:
The system will continue to drive the coils at the maximum pulse width while the LEFT/RIGHT switch is
held.
NO SWITCHBOX INSTALLED
• AUTO MODE - When the Steerable Hitch node is in AUTO MODE, the implement will compensate for turns
made by the tractor to maintain track alignment between the tractor and the implement. When AUTO mode is
enabled, the system will default to it when the master switch is toggled. To enable AUTO MODE:.
1. From the Home Screen, ensure the master switch is activated under CONTROL MODE. If not, verify that the
toolbar is unfolded and the proximity sensor is detecting metal.
Summary of Contents for Unverferth NutriMax Series
