Raven Switch Pro, Installation & Reference Manual

Page: 13 / 32

APPENDIX
A
: 9
APPENDIX A
SWITCH PRO COMBO CABLE
The combo cable can be used in place of the Envizio Pro or Viper Pro main and auxiliary interface cables (P/N 115-
0171-745 and 746), CAN tee cables (P/N 115-0171-326 and 368) and Switch Pro console cable (P/N 115-0171-803).
NOTE: Be sure to follow the instructions in the Preparation section on page 1 and Best Wiring Practices
section on page 4 when installing the Switch Pro combo cable.
COMBO CABLE INSTALLATION
SPEED INPUT TERMINAL CONFIGURATION
NOTE: When using either Switch Pro combo cable (P/N 115-0171-820 or 821), make sure the cable is
configured for the speed source being used with the Switch Pro system.
• When using the Envizio Pro internal DGPS Receiver as the speed source, make sure the T2 and T1 terminals are
connected. This is the factory setting for the Switch Pro combo cables.
• When using any other speed input, connect the T2 and T3 terminals.
Tuck all three terminals into the cable sleeve or conduit.
NOTE: Refer to Appendix B, System Diagrams, for detailed system connection diagrams. These drawings may
be helpful for understanding the Switch Pro system and connections.
POWER CONNECTIONS
1. Connect both of the power leads to a controlled clean power source.
2. Connect both of the ground leads directly to the battery’s ground terminal. DO NOT use a chassis ground.