MOUNTING DYNAMIQ ISO AND STU | SBGUIDANCE | SMARTRAX MD
PAGINA 30/48 | Installation manual | 016-8000-098EN | Rev. A
Raven Industries Inc.
5
MOUNTING DYNAMIQ ISO AND STU
The following guidelines have been established for
mounting the DynamIQ ISO and STU:
Preferably, place the STU and DynamIQ ISO
next to and to the right of the seat. Use the
standard DynamIQ ISO mounting bracket.
Place the DynamIQ ISO on top of the STU.
If it is not possible to attach the DynamIQ ISO
to the seat bolts, the DynamIQ ISO should be
attached in an appropriate place in the cabin
that is free from vibrations. Also the STU has to
be mounted somewhere else in the cabin.
A DynamIQ ISO may only be mounted in a
horizontal position (with the sticker side up).
The connectors may be orientated in four
directions (0, 90, 180, 270 degrees).
By default, the orientation of the DynamIQ ISO
is set to: horizontal position with connectors
pointing towards the rear (as shown in Figure
33). Any other orientation should be set in the
software!
FIGURE 33 DYNAMIQ ISO AND STU MOUNTED
NEXT TO THE SEAT.
