C
HAPTER
4
32
ISOBUS Product Control Installation & Operation Manual
ALARMS SETUP TAB
In addition to the product control capabilities of the Raven ISOBUS product control system, the ISOBUS
communication protocol offers excellent error detection capabilities, making it very suitable and reliable for
agricultural applications. Access the Alarms Setup screen to configure the following alert conditions which may be
displayed during ISOBUS product control operation:
•
Low Tank/Bin
•
Low Limit
•
Off Rate Percent
•
RPM Off Rate Percent (Granular applications only)
•
Dual Encoder Error Percent (Granular applications only)
•
Bin Level Sensor (Granular applications only)
•
Low Pressure (NH3 applications only)
If any of these alarm conditions is detected by the product control node, the corresponding alert will be displayed
on the VT display and allow the operator to respond to the condition before resuming application.
NOTE:
Select the “OK” button on the alarm prompt to clear the alarm and return to the previous screen. The
alarm condition may still be present after the alarm prompt is cleared. The product control home
screen will continue to display an alarm condition indicator until the issue is resolved.
LOW TANK
Enable the low tank alarm to display an alert when the calculated volume of product remaining in the tank drops
below the desired value.
LOW LIMIT
The low limit value sets the minimum volume per minute which a product will be applied. If the flow meter drops
below this setting, the VT terminal will display an alert.
NOTE:
The product control valve will stop closing when the low limit setting is reached.
Summary of Contents for ISOBUS Product Control
