Raven Force Evo, Installation Manual

Page: 18 / 32

C
HAPTER
4
14 Force Evo Injection System Installation Manual
2. Connect the chemical collection container to the 3-way valve at the in-line mixer. Contact a Syngenta supplier
to obtain the chemical collection kit.
3. Place the 3-way valve in the position to by-pass the point of injection and to discharge the system to the
chemical collection container.
4. Next, connect the clean out hose to the quick coupler in the injection cabinet.
5. Secure the open end of the clean out hose above the coupler to keep chemical from flowing out the hose. This
will vent the injection manifold to air.
NOTE: To rinse the injection pump and plumbing, place the open end of the clean out hose in a container of
RV anti-freeze and perform the following steps.
IMPORTANT: Do not rinse with water. Water can have an adverse affect on the chemical.
6. If a Raven control console is installed for carrier control, enter a self test speed of 6 mph [10 km/h] and set the
injection pump to automatic control mode.
NOTE: Do not run the carrier during this procedure.
Refer to the Raven control console manual for details on entering and using the self test speed
feature. The self test speed will clear if any signals are received from an actual speed sensor. To keep
the self test speed from clearing during the rinsing procedure.
7. Toggle the injection pump to automatic control mode.
8. Toggle the master switch and at least 1 section switch to the on position.
9. Run the injection pump for 2 minutes.
10. Toggle the injection pump to the off position.
11. Move the clean out hose to the next coupler and repeat step 7 through step 11 until all box connectors in the
injection cabinet have been flushed or rinsed.
NOTE: Refer to the Winterizing the Force® Evo Injection System section on page 17 for information on
winterizing the Force
®
Evo system.