Raven Envizio Pro, Installation And Operation Manual

Page: 42 / 287

3
P/N 016-0171-493 Rev. I 27
Installation
SmarTrax™
Envizio Pro field computers are capable of operating with optional Raven hydraulic and mechanical drive
assisted steering systems such as Raven SmarTrax or SmarTrax MD.
GPS signal is routed into the SmarTrax controller and then fed into the field computer via the ‘DGPS’
connector on the Envizio Pro main interface cable (P/N 115-0171-746) or chassis interface
cable (P/N 115-0172-001).
When the SmarTrax system is engaged, the assisted steering system controls the vehicle steering system,
either hydraulically or by mechanically turning the steering wheel, to guide the vehicle along a guidance path
displayed on the field computer Guidance screen. See the
Source section on page 133 to configure the
Envizio Pro to use an optional SmarTrax system.
Serial Console
FIGURE 11.
Envizio Pro Gen 1 Cable Platform with Serial Control Console
The Envizio Pro may be connected to a Raven serial control console via a serial port connection. In this
configuration, the field computer is primarily used for the data logging, mapping, and guidance.
Note:
If connected to a serial control console, the field computer does not require a separate boom/
speed or product control node. An AccuBoom, AutoBoom, or SmarTrax node still may be
connected to the field computer.