![background image](http://html.mh-extra.com/html/raven/dcs-300/dcs-300_installation-and-service-manual_788816010.webp)
6
3.
MOUNTING THE CONTROL VALVE
l)
l)
l)
l)
l)
Mount the motorized Control Valve in the main hose line between the Flow Meter
and the boom valve, with motor in the upright position. (For less than 3 GPM [11
lit/min], the motorized Control Valve is mounted in the by-pass line, refer to
Appendix 1
for alternate plumbing diagram).
2)
2)
2)
2)
2)
Connect the Flow Control Cable connector to the boom valve, Flow Meter, and
motorized Control Valve.
4.
MOUNTING THE CONSOLE AND CABLING
l)
l)
l)
l)
l)
Mount the Console to secure support inside the cab of the vehicle.
2)
2)
2)
2)
2)
Connect the Console Control Cable to the plug in the back of the Console. Route
the cable out of the vehicle cab. (Flow Meter extension cables are available from
your Dealer).
3)
3)
3)
3)
3)
Turn POWER switch OFF and route Red and White battery wires to a 12-Volt battery.
Attach White battery wire to the NEGATIVE
NEGATIVE
NEGATIVE
NEGATIVE
NEGATIVE (-) battery terminal, and the Red battery
wire directly to the POSITIVE
POSITIVE
POSITIVE
POSITIVE
POSITIVE (+) battery terminal. See
Figure 4 on page 7
. (DO
(DO
(DO
(DO
(DO
NOT CONNECT RED AND WHITE WIRES TO THE STARTER)
NOT CONNECT RED AND WHITE WIRES TO THE STARTER)
NOT CONNECT RED AND WHITE WIRES TO THE STARTER)
NOT CONNECT RED AND WHITE WIRES TO THE STARTER)
NOT CONNECT RED AND WHITE WIRES TO THE STARTER). Secure the battery wires with
plastic cable ties. DO NOT
DO NOT
DO NOT
DO NOT
DO NOT tie battery wires close to existing battery leads or
any other electrical wiring.
4)
4)
4)
4)
4)
Connect the Encoder Sensor Cable to the plug in the back of the Console.
5)
5)
5)
5)
5)
Secure and tie the Encoder Sensor Cable and Console Control Cable with plastic
cable ties.
6)
6)
6)
6)
6)
Initial installation of the system is now complete.
FIGURE 3