CALIBRATE SC1 | CRX + SC1 AUTOSTEERING | RAVEN EUROPE GENERIC
PAGE 18/37 | Calibration manual | 016-8000-015EN | Rev. A1
Raven Industries Inc.
41
Hold the steering wheel on the right and
press the ‘Voltage’ underneath right. The
current voltage is setup as the right voltage
(check if the voltage on right changes to the
current voltage).
Select the ‘
Next
’
arrow.
42
Press and hold the ‘MIN’ button and look at
the value at Wheel Velocity. The minimum
steering speeds for as well left as right
should be around (-) 1.00 deg/sec.
43
Higher or lower the ‘MIN’ steering
percentage by pressing on the
–
or
+
sign
next to the percentage. After adjusting, press
‘MIN’ again and watch the Wheel Velocity.
When this is around 1.00 deg/sec, leave it at
this value. Most likely this will be around 17
till 20 percent.
Perform this for left and right and press the
checkmark on the bottom
52
A summary of the calibration is shown. Press
the checkmark to enter the main screen of
the UT from the ISO Raven Steering
Controller.
press the ‘Checkmark’.
