4
CAN Switch Box Operation
Important:
The CAN Switch Box must be used as the primary control interface
for section, master or product control status.
Make sure to toggle the master switch to the off position when closing or
exiting a job to avoid unintentional product application once the field
computer or control console closes application management functions.
It
is also good practice to shut off product and section switches when the
application system is not being used.
The CAN Switch Box puts the section and product control modes right at the
operator’s finger tips.
Refer to the following sections for detailed
operation of the CAN Switch Box:
Logic Power LED
This LED indicates the status of CAN logic
power into the CAN Switch Box. This LED
should be on (solid) during normal
operation.
The Logic Power LED will begin flashing if
low logic power is supplied to the CAN
Switch Box. Troubleshoot the logic power
system before proceeding with operations.
If this LED is not lit when the Raven console or field computer is powered up,
troubleshoot the CANbus system before starting any system operations.
Transport/Plant Mode Switch
The transport mode switch is used lock out switch box functions when the
implement is being transported over the road or when ready for work in the field.
TRANS.
Toggle the mode switch to “TRANS” mode when transporting the
implement. This mode allows the operator to use the fold, wing, and latch
features.
PLANT.
Toggle the switch to field “PLANT” mode to use the switch box during field
operations.
Transport/Plant
Mode Switch
Logic
Power LED
