Raven AutoBoom RoGator 54 Series, Installation Manual, Page: 39 / 74

4
Manual No. 016-0230-018 35
PowerGlide Plus
Install the PowerGlide Plus Wiring
Wiring Connections
For wiring connections made outside the cab, apply dielectric silicone grease (P/N 222-0000-006) generously
on both the male and female ends of the connectors. Application of the grease will prevent corrosion to the
pins and wires.
Install the AutoBoom Node
FIGURE 13.
AutoBoom Node Installed
1.
Mount the AutoBoom node (P/N 063-0130-010) to the valve mounting plate (P/N 107-0171-802) using three
3/8”-16 x 1-1/4” zinc hex bolts (P/N 311-0054-106) and three 3/8”-16 zinc flanged lock nuts (P/N 312-1001-
164).
Note:
Position the node so that the cable connections face to the side or down.
2.
Insert the large, rectangular node connectors on the harness cable (P/N 115-0230-045 or 115-0230-085)
into the correct ports of the AutoBoom node.
3.
Tighten the bolts on the node connectors to secure the connections.
Connect the Harness to the Boom Function Controls
1.
Locate the Left Press and Right Press connectors on the AutoBoom harness cable (P/N 115-0230-045 or
115-0230-085).
2.
Route the connectors to the AutoBoom valve (P/N 063-0131-126).
3.
Connect the Left Press connector to Port G1 on the AutoBoom valve.
4.
Connect the Right Press connector to Port G4 on the AutoBoom valve.
CAUTION
Always connect the power cable as the last
step in the wiring process and verify that the
power leads are connected with the correct
polarity. Reversing power leads can cause
severe damage to the equipment.