CHAPTER
6
P/N 016-0230-047 Rev. C
27
CHAPTER 6
WIRING INSTALLATION
WIRING CONNECTIONS
For wiring connections made outside the cab, apply dielectric silicone grease (P/N 222-0000-006) generously on
both the male and female ends of the connectors. Application of the grease will prevent corrosion to the pins and
wires.
INSTALL THE AUTOBOOM NODE
FIGURE 1. AutoBoom Node Installed
1. Secure the AutoBoom node (P/N 063-0130-013 or 063-0130-053) to the valve hydraulic mounting bracket using
three 3/8”-16 zinc hex bolts (P/N 311-0054-081) and three 3/8”-16 zinc flanged lock nuts (P/N 312-1001-164).
NOTE:
Position the node so that the cable connectors face down.
2. Insert the large, rectangular node connectors on the harness cable (P/N 115-0230-073) into the corrector ports
of the AutoBoom valve.
3. Tighten the bolts on the node connectors to secure the connections.
CAUTION
Always connect the power cable as the last step
in the wiring process and verify that the power
leads are connected with the correct polarity.
Reversing power leads can cause severe damage
to the equipment.
