5.2.6.3 Serial Set
Enter into the [Main menu
Device
Serial Set] interface shown as Picture 5-48.
5.2.7 System
5.2.7.1 General
Click [Main Menu
System
General] to enter into the interface shown as Picture 5-49
Note:
The above [NTP function] change will be available only when system connected to internet. And When NTP
function is set to “Enable”, system will calibrate the time at every 00:07:50 and every start-up.
You will be allowed to modify system date/time,
date/time format, time zone, language, video format and
menu time out.
And click [DST Setup] button to enter into the below
interface shown as Picture 5-50, and you are allow to
configure DST status and mode.
Click [NTP setup] to enter into the interface shown
as Picture 5-51 and now allow you enable/disable
the NTP function.
When operate DVR via keyboard, it is required to set
communication protocol.
Baud rate:
set baud rate of serial communication.
Data bit:
set data bit of serial communication.
Stop bit:
set stop bit.
Parity Check:
set parity check to <None> or other.
Picture 5-48
Picture 5-49
Picture 5-50
Picture 5-51
25
