Brochure for models with FLASH motherboard
( fi rmware version ECT2008air - & ECT2008box - )
PAGE
2.0 sUppLeMentaRY FUnCtiOns 7-KeY DispLaY (aiR models)
in addition to the phases described in section 1, functions exist that can be activated on the
display:
• SELECTION OF RECIPE ACCORDING TO TYPE OF INSTALLATION (protected by password B9)
• ZERO SET HOURS MENU
(protected by a password 35)
• DEFAULT SETTING MENU
(protected by a password A9)
• DATA BASE MENU
(protected by a password)
nOte: the functions accessible to the UseR are illustrated below:
- CLOCK setting MenU
- ChROnOtheRMOstat set MenU
- LangUage MenU
- aUtOMatiC LOaDing OF aUgeR
- peLLet-aiR BLenD setting
2.1. automatic loading of auger
On fi rst ignition, automatic feeding of the auger must be carried out in this way: press button p4 for about 3” until the set CLOCK
MenU appears on the display. then click button 4 until you reach “Menu 5 state stove”, then click button 6 to enter. then by
pressing button 5, change the screw status to 1. this will now turn the auger on for approximately 2 mins.
n.B. Remember to empty the fi re pot before igniting the stove. automatic auger feeding must be carried out only when the
stove is in the OFF or FinaL CLeaning status.
2.2 Modify air - pellet blend: “ChOOse ReCipe“
When fi rst installing a stove you can modify the pellet-air blend. to access the “ReCipe” menu: hold button down 4 for 3 seconds.
then click button 4 until you reach menu 10 “seLeCt ReCipes”, click button 6 to enter. Use button 5 and change the access code
to B9. now you can change which recipe you need by using the chart below.
ReCipe
peLLet LOaD
sMOKe DRaUght
hORiZOntaL Venting
from pR06 to pR10
0
from pR18 to pR22
+25 %
hORiZOntaL Venting
from pR06 to pR10
0
from pR18 to pR22
+15 %
OFF
-
0
-
0
VeRtiCaL Venting
from pR06 to pR10
10 %
from pR18 to pR22
-15 %
VeRtiCaL Venting
from pR06 to pR10
15 %
from pR18 to pR22
-25 %
n . B . the various loads and draught values related to each menu section are added to any load and draught values of input
the procedure described in paragraph. 2.3.
n.B.: the recipe specifi ed above are not available for the eCt2008aiR/BOX01 version.
2.3 - pellet - air blend setting (in use of enduser)
setting the air - pellet blend allows the speed of both the smoke engine and the pellet feeding auger to be changed. this allows
combustion to be adjusted by the end-user according to the stove’s draught and according to the hardness of the pellet, in case
this diff ers from original when fi rst installation is done to access to settings press p6 and p7 together until “0 peLLet 0 DRaUght”
appears.the quantity of pellet is changed with keys 4 and 5.
the speed of the smoke engine is changed with keys 6 and 7.
12
