6
Fin Installation
Screw & Nut plate is already installed onto SUP Board.
Step 1: Untighten screw and slide nut plate to the front of fin box and remove screw.
Step 2: Insert the pin end of the fin into the center slot of the fin box. NOTE: The fin
mounting hole should be facing towards the front of the board.
Step 3: Push down and slide fin to the back of the fin box. Ensure the fin is flush with the
bottom of the board as shown in Fig. 5.
Step 4: Align the screw hole on the fin and the nut plate.
Step 5: Using fingers only, start screw into nut plate. Tighten with screwdriver to snug
.
NOTE: DO NOT OVER TIGHTEN
1
2
3
4
3
5
