Instruction manual
RAVTD3000 - RAVTD3000HP
RAVTD3000NRC - RAVTD3000ATS
Code M0215 - rev.1.1
(11/2012)
RAVAGLIOLI S.p.A.
Page 10/52
RAVAGLIOLI S.p.A. -
Via I° Maggio, n° 3 (Pontecchio Marconi)
40037 Sasso Marconi (Bologna - Italy)
Tel. 051/ 67.81.511 – Fax 051/ 84.64.67 E-mail: [email protected]
RAV TD3000
4-point self-centering holding
clamps, fitted with targets (for
rims from 10'' to 24'')
RAV TD3000NRC
4-point self-centering resting
clamps, fitted with targets (for
rims from 10'' to 24'')
RAV TD3000ATS
RAV TD3000HP
3-point self-centering resting
clamps, fitted with targets (for
rims from 8'' to 24'')
3D object
characterisation
in space
position abbreviation
(FL = FRONT LEFT)
Graphic symbol sticker that shows
the position (see par. 5.2.3), applied
both on target on clamp
3.5 Clamps
with
target
Three different types of clamps, a target must be fitted on them, as below described.
They are all of self-centering type, with removable tabs.
Figure 3
They are marked as Front Left and Right and Rear Left and Right, according to the following
table (see Figure 4):
FL = FRONT LEFT
FR = FRONT RIGHT
RL = REAR LEFT
RR = REAR RIGHT
Warning: the inclination of the target is determined at installation time, as described in the
par. 5.2.3
Once the target is fixed, during the procedure, is only required to fasten the clamps,
making sure to position them vertically (see figure above).
Each target features a barcode as well, describing the characteristics of the 3D object.
Clamp + target calibration and progressive production number for traceability, are included
also in the above code.
Figure 4
