Rauch K 51, Instruction Manual

Page: 30 / 64

Commissioning 6
24
6.2 Preparing the operating mode
In the state as delivered, the machine is set to manual operation. This means that
the spreading disc and the agitator fingers rotate when the machine is pushed.
To ensure the machine can work in minitractor operation, the couplings at the
wheels must be swapped.
1. Remove the linkage pin from
the axle at the right wheel.
2. Remove the coupling from
the axle.
3. Remove the linkage pin from
the axle at the left wheel.
4. Remove the coupling from
the axle.
Figure 6.1: Axle with old coupling
5. Swap both couplings.
Figure 6.2: Swap couplings
6. Push a linkage pin on each
end of the axle.
Figure 6.3: Axle with linkage pin