Rauch AXENT Series, Operator'S Manual

Page: 143 / 170

General maintenance and servicing
137
9
5. Adjust the position of the belt scraper on the conveyor belt.
See
9.9: Adjusting the belt scraper, page 139 .
6. Start running the belt by means of the AXENT ISOBUS machine control unit.
7. Stop the belt after one minute.
8. Check the position of the conveyor belt on the tension pulley and readjust it if
necessary.
9.8.2 Setting the tension of the conveyor belt
Check the tension of the conveyor belt after the first few hours of operation or if
you notice any slippage at the conveyor belt.
The tension pulleys of the conveyor belt are located at the front between the
container and the frame in the direction of travel.
1. Check the position of the disc
spring packages [2].
Nominal dimension in
pre-tensioned installation
position of all disc
springs = 56 mm
Half of the disc spring pack-
ages are flush with the posi-
tion plate on both sides [1]:
28 mm +/- 1 mm,
10 disc springs
2. Re-tighten the disc springs if
necessary.
Figure 9.17: Re-tightening the disc spring
packages
1
2