43
NOTE:
This charger is designed to detect some problems that
can arise with battery pack. (see table below)
Light
ON/OFF flash
Status
Green flash
- - - - -
Charging
Green on
Fully
Charged
3. TO REMOVE OR INSTALL BATTERY PACK(SEE
FIG B)
Depress the battery pack release button to release
and slide the battery pack out from your tool. After
recharge, slide it back into your tool. A simple push
and slight pressure will be sufficient.
OPERATION
1. ON / OFF SWITCH (SEE FIG. C)
Depress the On/Off switch to start and release it
to stop your drill.
The on/off switch is fitted with a brake function
which stops your chuck immediately when you
quickly release the switch.
It is also a variable speed switch that delivers
higher speed and torque with increased trigger
pressure. Speed is controlled by the amount of
switch trigger depression.
WARNING: Do not operate for long
periods at low speed because excess
heat will be produced internally
2. SWITCH LOCK (SEE FIG. D)
The switch trigger can be locked in the OFF
position. This helps to reduce the possibility of
accidental starting when not in use. To lock the
switch trigger, place the rotation control in the
center position.
3. REVERSÍVEL (VER FIG. E1, E2)
For drilling and screw driving use forward rotation
marked “
” (lever is moved to the left).
Only use reverse rotation marked “
”
(lever is moved to the right) to remove screws or
release a jammed drill bit.
WARNING: Never change the direction
of rotation when the chuck is rotating,
wait until it has stopped!
A3
B
C
D
