pg. 5
Key Pad
Programming the Phone:
1. You can program the phone on-site or remotely.
2. If programming on-site, open back access panel located directly behind front stainless steel face
plate. Use the #10 spanner bit provided to remove the 6 security screws.
3. Remove the cover of the NEMA 4 enclosure by loosening the 4 corner screws.
ONSITE PROGRAMMING:
Step 1. To Begin Program mode
A. Press
Enter
Step 2. To Program Emergency Numbers
A. Press
1
,
Enter
, (phone number),
Stop
Note: Press
2-5
in step 2A for Emergency numbers
2-5 as needed
Step 3. To Program Location message
A. To turn on message Press
1
,
3
,
Enter
,
2
B. Press
6
,
Record
(speak message)
Stop
(to replay message Press
6
,
Play
)
C. For no message Press
1
,
3
,
Enter
,
0
Step 4. To exit program mode
A. Press
Stop
for 3 seconds
REMOTE PROGRAMMING:
Step 1. To Begin Program mode
A. Call into phone by dialing the cellular number of the tower
B. After 1st simulated ring Press #, # (Wait for 4 tones)
C. Key in security code (default is 1111) (Wait for confirmation tones)
Step 2. To Program Emergency Numbers
A. Press 1, *, (Phone number), *, # (Wait for confirmation tones)
Note: Emergency numbers (2-5) Repeat Step 2A; pressing (2-5) as needed.
Step 3. To Program Location Message
A. To turn on message Press 1, 3, *, 2 (Wait for confirmation tones)
B. Press 6, *, (speak message) #, *, # (Wait for confirmation tones)
a. (to replay message press 6, #) (Wait for confirmation tones)
C. For NO message Press 1, 3, *, 0 (Wait for confirmation tones)
Step 4. To Exit Program Mode
A. Press *, #, 0 (you will hear beep, beep) *, # (You will hear a buzz)
www.rathsecurity.com
