Ratek WBx000D Series Water Bath - User Manual
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Page 8 of 21
CAUTION
Always work above the level of the water bath to avoid spillage of dangerously hot water. At no point should the user, operator,
animal or any other perishable object be situated directly beneath the water bath.
-
ALWAYS
wear protective eyewear when working with hot liquids.
-
ALWAYS
place the water bath on a strong, even, dry, flat waterproof surface which is made of inflammable material.
Placing the water bath on an unstable surface could cause hot water to spill.
-
ALWAYS
empty the water bath before moving the equipment to a new location.
-
ALWAYS
turn off the mains power switch (element 6 in Figure 1) when the unit is not in operation and turn off the mains
power supply at the outlet.
-
ALWAYS
turn off the mains power switch (element 6 in Figure 1) and unplug the equipment from the mains power supply
outlet before emptying the water tank or moving the equipment.
-
ALWAYS
be careful of water condensation above or near the water bath and ensure at all times that the condensation
cannot come in contact with the water bath control panel or mains power lead. Ensure benches are kept dry at all times.
-
ALWAYS
operate the water bath in a well ventilated area with adequate clearance around the water bath as indicated.
-
ALWAYS
be careful of steam and avoid making contact.
-
NEVER operate the water bath without water in the water tank.
-
NEVER
empty the water bath while it contains hot water. Always allow the water to cool to ambient room temperature
before emptying.
-
NEVER
operate the equipment if you believe it is damaged in any way.
-
NEVER
operate the water bath if the mains power supply cable is damaged in any way
-
NEVER
use any sharp or metal objects near the water bath control panel.
-
NEVER
lift the water bath if you have an existing injury that impairs your ability to lift.
Preparation & Installation
The water bath should be installed and operated in strict accordance with the following instructions.
CAUTION
The water bath is not for use in explosive atmospheres as there is a risk of fire, explosion, burns or scalding present under
these conditions.
CAUTION
Be careful when lifting and observe your local operational health and safety requirements for lifting before unpacking the carton.
Unpacking and Installing
-
Carefully remove all packaging material from the water bath, as well as the supplied User Manual and any other supplied
accessories.
-
Carefully inspect the water bath, mains power lead and all packaging for any signs of damage. If any signs of damage are
present,
do not
install or operate the equipment. Contact the supplier of your equipment if you have a received a damaged
product.
-
Place the water bath in an upright position as per Figure 1 on a strong, even, flat waterproof surface which is made of
inflammable material.
-
Ensure that there is a minimum unobstructed distance of 100 millimetres between the left, right and rear panels of the
water bath and any other object or wall.
-
Ensure that there is a minimum unobstructed distance of 500 millimetres above the top of the water tank to allow for
adequate ventilation.
-
Ensure that there is a suitable mains power supply outlet within reach of the supplied mains power lead without placing any
