EN
11
12. BATTERY CHARGING
When the battery is empty, it is necessary to recharge it using only the special docking
station supplied with the device.
The docking station must be connected to the standard charger with European or American
plug, also supplied with the scissors.
WARNING
Always check if the charger voltage corresponds to the network voltage of the country
where the scissors are used.
Never use chargers other than those supplied (100-
240VAC, 50/60 Hz, 0.4A max - Output: 4,2V, 2A).
Remove the battery "A" from the motor by pressing
the appropriate orange "B" buttons on the top and
bottom of the battery (see picture 5), then insert it
into the "C" docking station as shown in picture 6.
Never use batteries other than the one supplied (3,7V
rechargeable with Lithium
®
Ion technology).
It is possible to control the recharging operation through
the LED light located on both the docking station and
the charger. These LEDs indicate:
- battery charging (red colour)
- fully charged battery (green colour)
Using the standard charger CH36 (with European plug)
or CH3601 (with American plug), the time required for
a full charge is approx. 4 hours.
WARNING
5
A
B
6
A
C
