10
EN
13. LUBRICATION
Every 3-4 working days it is necessary to lubricate the pair
of gears.
To carry out this operation, remove the protective plug
“A” located on the motor support of the cutting unit and
fill it with lubricating grease Rasor.
Screw plug “A” again a few turns. Screw plug “A” a few
turns every 2-3 working days (see picture 9).
The blade must never be dirty with grease or oil.
9
WARNING
A
12. BLADE SHARPENING
After many hours of a continuative use of the cutting
unit, or if it would not be able to cut anymore, it is
necessary to sharp the blade.
To carry out this operation, start the blade and press
sharpener “2” located on it for 3-4 seconds (by pressing
push button “1”, as shown in picture 7).
Repeat the operation 2-3 times.
If the sharpening operation is not effective, check the
wear of emery grinding wheel “3” (see picture 8).
If emery grinding wheel “3” is too worn or dirty, replace
it.
1
2
8
3
7
