Rotisserie
skewer insertion hole lid
skewer grid on third rack
skewer insertion hole
skewer tip
skewer
skewer handle
tray on first rack
Use of rotisserie accessories
Pass the skewer through the chicken and lock the
clamps, insert the tip of the skewer into the hole found
at the rear panel of cavity and make sure that it
completely leans on the frame and fits in motor shaft. To
do this, first you have to turn the lid to the side, which is
found in front of the skewer insertion hole, as shown in
the figure. After that, fit the skewer fit the skewer onto
the skewer grid which you will place on the third rack.
Remove the handle from skewer, if it is installed and
close the oven door. The handle must be atteched only
for removing the food after grilling.
Make sure that the oven is not operating while performing these operations.
Spit
Rotisserie bearing
bracket or rotisserie
bearing grid
Tray
Spit handle
Spit hole on back
panel of oven
Small metalic
cover
Pull out the clamps on spit by loosening
their screws and stick the spit into
chicken. Then, mount the clamps by
sliding them on the spit and stick the
clamps into chicken. Tighten their
screws. Before doing any operation
described below, be sure that oven and
rotisserie function is not in operation. Put
the tray on second shelf and locate the
rotisserie bearing bracket for spit in the
holes on the tray as shown in figure.
Some products may have rotisserie
bearing grid accessory instead of the
rotisserie bearing bracket for spit and
Placed on first shelf. ýn this case, you only need to place the bearing grid on third shelf.
Before locating the point tip of spit into hole at back panel of oven, turn the small metalic
cover and see the hole. Place the point tip of spit into hole at back panel of oven and the
bearing tip of spit on the rotisserie bearing bracket or rotisserie bearing grid firmly. Also, be
sure that the point tip of spit is placed into hole firmly. During rotisserie, spit handle must
never be mounted to spit and oven door must be in closed position.
18
