Rasmussen Solaire, Use And Care Manual

Page: 5 / 28

Locating & Assembling the Grill
Page 3
When determining a suitable location,
take into account concerns such as
exposure to wind, proximity to traffic
paths and keeping any gas supply lines
as short as possible. Locate the grill
only in a well-ventilated area. Never
locate the grill in a building, garage,
breezeway, shed or other such enclosed
areas with out an approved ventilation
system. During heavy use, the grill will
produce a lot of smoke.
CLEARANCE
To Non-Combustible Construction
A minimum of 3" clearance from the
back of the grill to non-combustible
construction is required for the lid to
open fully.
To Combustible Construction
Do not install this unit into combustible
enclosures without the use of a suitable
insulated jacket or by maintaining a
minimum clearance of 12" between
the grill and any combustible materials.
If your enclosure is combustible, then the
installation of an INSULATED JACKET
manufactured by SOLAIRE INFRARED
GRILLING SYSTEMS, is required.
Please refer to the cut out sizes for
INSULATED JACKETS on Page 15.
ASSEMBLY
Built-in Models
Before locating your SOLAIRE
INFRARED Grill into your Non-
Combustible enclosure, complete the
following steps:
1.Remove all packaging materials.
2.Ensure that the burners are positioned
correctly on their orifices, and are
fully seated onto their supports.
3.Ensure that a NEW battery is fitted
to the push button igniter. (See
Figure 1 below).
4. Make the connection to the gas
regulator at the rear of the Grill with
a flexible connector. Ensure that the
connection is tight.
Your SOLAIRE INFRARED Grill can
now be located into the enclosure.
Pass the flexible gas connector
through the access hole located in
the support base of the enclosure for
final connection to the gas supply.
Free Standing Models
Your SOLAIRE INFRARED Grill has pro-
vision for mounting onto the mobile
cart by bolting from below. With the
help of an assistant set the grill on the
mobile cart. Align the mounting holes
in the base of the Grill with the holes
on the top flange of the mobile cart.
Once mounted, secure the grill to the
mobile cart with the four bolts provided
and tighten securely.
Complete the following steps:
1.Remove all packaging materials.
2.Ensure that the burners are positioned
correctly on their orifices, and are
fully seated onto their supports.
3.Ensure that a NEW battery is fitted
to the push button igniter. (See
Figure 1 below).
4.Make the connection to the gas
regulator at the rear of the Grill with
a flexible connector. Ensure that the
connection is tight.
AA
Ba
ttery
Insert positive end of AA
battery into main body of
ignitor first.
Front Control Panel
Figure 1
Igniter Battery Installation Instructions:
Stretch spring to
ensure electrical
contact