Page
14
of
18
Installing and Unpackaging
Warning:
Please switch off water supply to the dispenser before replacing
filters.
1.
Unpack the product, install the drip tray.
2.
Use of the Quick Connector:
Connect the tubing
The system includes push-in fittings for quick tubing connection. Review the
following instructions before connecting the tubes in the next step.
Cut the tubing to length
1)
Use a sharp cutter to cut the end of tubing.
2)
Inspect the end (about 30mm) of the tubing to make sure there are no
nicks, scratches or rough spots. Cut the tubing again if needed.
Connect tubes
1)
Push tubing through collet until it engages the O-ring. Continue pushing
until the tube bottoms out against the back of the fitting. (Stopping when
the tubing just engages the O-ring may lead to future leaks) Tubing will
be fully engaged when 20mm of tubing has entered the fitting.
Disconnect tube:
1)
Push the collet inwards with fingertips and hold it.
2)
Pull the tubing out.
3.
Take out the quick joint and install it on the water pipe.
Tube partially engaged with fitting
Tube fully engaged with fitting
