Rasha Professional A/S 375 W Esplanade Ave. San Jacinto, CA 92583
|
951-654-3585
rashaprofessional .com
|
[email protected] Rev. 101615
13
With this feature you can connect the fixtures to one another using the IEC
input and output sockets. The quantity that can be connected is 33 fixtures
maximum. After 33 fixtures you will need to use a new power outlet. They must
be the same fixtures. DO NOT mix fixtures.
Disconnect the unit from its power source. Remove the power cord from the
unit. Once the cord has been removed, you will find that the fuse holder is
located inside the power socket. Insert a flat-head screw driver into the power
socket and gently pry out the fuse holder. Remove the bad fuse and replace
with a new one. The fuse holder also has a holder for a spare fuse
Power Cord Daisy Chain
Fuse Replacement
Trouble Shooting
Listed below are a few common problems the user may encounter, with solutions.
Unit not responding to DMX:
1. Check that the DMX cables are connected properly and are wired correctly (pin
3 is “hot”; on some other DMX devices pin 2 may be ‘hot’). Also, check that
all cables are connected to the right connectors; it does matter which way the
inputs and outputs are connected.
Unit does not respond to sound:
1. Quiet or high pitched sounds will not activate the unit.
2. Make sure that Sound Active mode is activated.
Cleaning
Due to fog residue, smoke, and dust cleaning the internal and external optical
lenses must be carried out periodically to optimize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the outside casing.
2. Clean the external optics with glass cleaner and a soft cloth every 20 days.
3. Always be sure to dry all parts completely before plugging the unit back in.
4. Cleaning frequency depends on the environment in which the fixture operates
(i.e. smoke, fog residue, dust, dew).
Due to fog residue, smoke, and dust cleaning the internal and external optical
lenses must be carried out periodically to optimize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the outside casing.
2. Clean the external optics with glass cleaner and a soft cloth every 20 days.
3. Always be sure to dry all parts completely before plugging the unit back in.
4. Cleaning frequency depends on the environment in which the fixture operates
(i.e. smoke, fog residue, dust, dew).
