Rascal AutoGo Owner’s Manual
EMC Part: 19286400 Rev.01 03/09/07
48
Controller Fault Codes
In addition to the troubleshooting information in the previous section, the controller used in the Rascal AutoGo provides
diagnostic information through means of a Fault Code Display that appears on the Battery Gauge. When a fault is
detected, selected segments of the Battery Gauge will light to indicate the faults. Codes and faults are listed in the
following.
Battery Gauge LED Segment Lit
Meaning and What To Do
1
Battery needs recharging or bad connection with battery. Check connections,
recharge battery.
2
Bad motor connection. Check all connections between controller and motor.
3
Short circuit between motor and battery connection. Contact authorized service
facility.
4 & 5
(not used)
6
Controller inhibited from operation. Disconnect battery charger.
7
Throttle fault. Engager levers must be in neutral (centered) position before
vehicle is turned on. Switch vehicle off, center levers, and switch back on.
8
Controller fault. Check all connections.
9
Bad parking brake connection. Check parking brake and motor connections.
10
Excessive voltage detected at controller. Check battery connections.
