Raritan PX2-1000 SERIES, User Manual

Page: 528 / 648

Appendix C: Configuration or Firmware Upgrade with a USB Drive
509
config.txt
To perform device configuration using a USB drive, you must:

Copy the device configuration file "config.txt" to the root directory of
the USB drive.

Reference the "config.txt" file in the
config
option of the
"fwupdate.cfg" file. See
fwupdate.cfg
(on page 506).
The file,
config.txt
, is a text file containing a number of configuration keys
and values to configure or update.
This section only introduces the device configuration file in brief, and
does not document all configuration keys, which vary according to the
firmware version and your PX model.
You can use Raritan's Mass Deployment Utility to create this file by
yourself, or contact Raritan to get a device configuration file specific to
your PX model and firmware version.
Regular configuration key syntax:

Each configuration key and value pair is in a single line as shown
below:
key=value
Note: Each value in the file must be separated by a single =
character, without any surrounding spaces.

As of release 3.1.0, multi-line values are supported by using the
Here Document Syntax
with a user-chosen delimiter.
The following illustration declares a value in two lines. You can
replace the delimiter
EOF
with other delimiter strings.
key<<EOF
value line 1
value line 2
EOF
Note: The line break before the closing EOF is not part of the value.
If a line break is required in the value, insert an additional empty line
before the closing EOF.