Technical Data
Safety Information
Laser
Measuring range (typically)
Measuring accuracy (typically)
Smallest unit displayed
Automatic switch off
Estimated battery life
Optimum operating temperature
Storage temperature
Batteries
Beam divergence
0.05-30m (0.164 - 100 feet)
+/-3 mm(+/- 1/8 inch)
1 mm(1/16 inch)
180 seconds
>3000 single measurements
32ºF to 104ºF (0ºC to 40ºC)
14ºF to 140ºF (-10ºC to 60ºC)
2 x 1.5V alkaline AAA**
0.6mrad
λ
=620-690nm, Laser class 2 ,
laser output<1mw
COMPONENT
SPECIFICATIONS
*Important: Under unfavorable conditions, such as in bright sunlight or
when measuring poorly reflecting or very rough surfaces, the tool’s
measuring range and accuracy will be reduced.
**Return your used batteries/rechargeable batteries free of charge to
the official collection points in your community, in our stores, or any
place where batteries or rechargeable batteries are sold.
Working safely with the measuring tool is possible only when the
operating and safety information are read completely and
instructions contained therein are strictly followed. Never make
warning labels on the measuring tool unrecognizable. SAVE THESE
INSTRUCTIONS.
Caution – The use of other operating or adjusting equipment or the
application of other processing methods than those mentioned
here, can lead to dangerous radiation exposure.
2
WARNING
Battery:
2 x AAA
1.5V
!
3
LASER RADIATION.
Do not stare into beam. Class 2 laser product.
Turn the laser beam on only when using this tool.
1.
Do not remove or deface any product labels.
2.
Avoid direct eye exposure.
The laser beam can cause flash
blindness.
3.
Do not
operate the tool around children or allow children to
operate the tool.
4.
Do not
place the tool in a position that may cause anyone to
stare at the laser beam, whether intentionally or unintentionally.
5.
Do not
use on surfaces such as sheet steel that have shiny,
reflective surfaces. The shiny surface could reflect the beam
back at the operator.
6.
Always turn the laser tool off when not in use.
Leaving the
tool on increases the risk of someone inadvertently staring into
the laser beam.
7.
Do not
attempt to modify the performance of this laser device in
any way. This may result in a dangerous exposure to laser
radiation.
8.
Do not
attempt to repair or disassemble the laser-measuring
tool. If unqualified persons attempt to repair this product, serious
injury may occur. Any repair required on this laser product
should be performed only by qualified service personnel.
LASER RADIATION
DO NOT STARE INTO BEAM
620-690nm / Power < 1mw
LASER CLASS 2 PRODUCT
CAUTION
WEEE Directive 2012/19/EU
At the end of the product life dispose of the packaging and
product in a corresponding recycling centre. Do not dispose
of the unit with the usual domestic refuse.
Do not burn the product.
