6 |
P a g e
RAPID TOOL Australia Pty Ltd
+61 2 8090 5999 | [email protected]
www.rapidtool.com.au
No.
Normal Operation
Problem
Warning
Sound
Cause
What to Check
Solution
Three short
beeps
repeated
Tie wire has run out.
Check if tie wire has run out.
Set the new tie wire.
Wire caught inside reel.
Check if wire inside reel has
been loosened and caught.
Remove fray on reel.
Cutter section is blocked with
foreign substance.
Confirm functioning of cutter
section.
Either wipe cutter section with
dry cloth or blow it with air as
per diagram above.
A wire is caught in the cutter
section or Wire guide A.
Check if any wire is caught.
Open the machine mouth to
access cutter section and
remove caught wire as per
diagram above.
3
Binding wire draws a
circle.
Curl is
distordered and
steps out of curl
guide.
No sound
emitted.
Wire, by hitting reinforcing
bars, was repelled.
Check if wire hits reinforcing
bars at binding.
Pay attention so that wire does
not hit reinforcing bars at
binding.
4
Wire is cut.
No wire cutting
takes place.
No sound
emitted.
Cutter section is blocked with
foreign substance.
Confirm function of cutter
section.
Either wipe cutter section with
dry cloth or blow it with air as
per diagram above.
Cutter or the cutting
mechanism is broken or worn
out.
Check the cutter, and each part
in cutting mechanism.
Open machine mouth and
replace with new part.
5
Wire twisting takes
place.
Wire gets
tangled.
No sound
emitted.
Wire, by hitting reinforcing
bars, was repelled.
Check if wire hits reinforcing
bars at binding.
Pay attention so that wire does
not hit reinforcing bars at
binding.