33
GB
ACCESSORIES
Pedal intended for trigging the stapling. When the pedal is connected, the
internal trigger is disabled.
Support table for the object to be stapled.
INSTALLATION
The Rapid 5050e/5080e is installed as follows:
1
Position the machine on a stable horizontal surface. The machine shall
be placed on a smooth and clean surface so that the feet are fixed to the
surface.
2
Check that the machine is suitable for the electrical power supply
available (voltage and frequency) by reading the data on the rating plate
(D). The machine must only be used with the supplied adapter, Rapid
5050e/5080e.
3
Insert the adapter’s plug into the electric supply and the low voltage
socket (N) to the machine.
OPERATION
Replacing the staple cassette
When only 19 staples are remaining in the cassette, the warning light (H)
changes from green to red. Replace the staple cassette (G) as follows.
See fig. 2 and 3:
Fill the machine with staples when required as shown in figure 3:
1
Press the visor (F) locking knob (E) and remove the visor.
2
Hold the cassette in its upper part and pull it straight horizontally
outwards.
3
Mount a new cassette in the opposite order.
4
Mount the visor. Check that its front part is correct positioned and that the
locking knob snaps up.
5
The warning light shows green and the stapling can start.
Adjusting the trigger position
See fig. 3
The distance between the staple and the edge of the stapling object is
determined by adjusting the staple depth with the lever (K). The distance is
read at the scale above the lever.
Note that corner stapling and edge stapling can require different positions.
epth
Inlaga00AA
00-06-06, 11.26
33