2. General advice
This manual contains important warnings and information.
Read and keep for reference.
Mishandling may cause damage or destruction of equipement or serious injury or death !
The pumps 110 HL 50/2 and 110 HL 200/2 are designed to be used in pumping greases only
! Any other use can cause unsafe operating conditions and result in component rupture, fire
or explosion, which can cause injury, including fluid injection !
WARNING !
2.1
No complying with below requests will result in severely harm to your
body even death.
Equipement misuse hazard
Equipment misuse can cause the equipment to rupture or malfunction in serious injury.
2.1.1
This equipment is for professional use only
2.1.2
Read all instruction manuals, tags and labels before you operate this
equipment.
2.1.3
Do not modify this equipment. If you need to replace worn or damaged
parts immediately.
2.1.4
Check equipment daily. Repair or replace worn or damaged parts
immediately.
2.1.5
Do not exceed the maximum working pressure of the lowest rate
component in your system.
2.1.6
Use fluids and sovents which are compatible with the equipment wetted
parts. Read the fluid and manufacturer‘s warnings.
2.1.7
Forbidden on other chemical or may cause damage to the pumps body.
2.1.8
Handle hoses carefully. Do not pull on hoses to move equipment.
2.1.9
Route hoses away from traffic areas, sharp edges, moving parts and hot
surfaces.
2.1.10
Do not use low pressure hoses in the system. Before operating the
control valve, put the hoses straight. Using of the hoses should comply
with certain conditions.
2.1.11
Put on heat insulation gloves when operating the pumps.
2.1.12
Do not move or lift pressurized euqipment.
2.1.13
Comply with all applicable local, state and national fire, electrical and
safety regulations.
2.2
Skin injection hazard
Fluid from the dispensing valve, leaks or rupture components can inject
fluid into your body and cause serious injury. Fluid splashes in the eyes or
on the skin can also cause serious injury.
2.2.1
Do not point the dispensing valve at anyone or at any part of the body.
2.2.2
Do not stop or deflect leaks with your hand, body, glove ir rag.
2.2.3
Do not use greases which have been polluted,
2.2.4
Use only extensions and no-drip tips which are designed for use with
your dispensing valve. Follow the pressure relief procedure it the grease
fitting coupler clogs and before you clean or service this equipment.
+49 (6158) 92980-0
3
