WARNING: PLEASE READ THIS MANUAL
CAREFULLY BEFORE USING THIS MACHINE
Machine is not rated and should not be used for commercial rebar production purposes.
1. Safety
This machine is a high performance, electric tool. Failure to follow safety instructions may result
in serious injury.
1. Authorized personal protective equipment must be worn when operating machine (minimum
requirement - protective gloves).
2. Take note of all warning signs on machine.
3. Keep body parts well clear of moving parts when machine is switched on.
4. Do not touch pump housing after use as it will be hot. Wait for machine to cool.
5. Use away from others, particularly children.
6. Never attempt to bend rebar outside of models prescribed diameter range (refer to table in
Specifications & Parts section).
7. Hold bender firmly and maintain proper footing and balance. Do not use at heights.
8. Never operate machine in wet or damp conditions.
9. Never attempt to service machine (other than general maintenance procedures outlined in
Maintenance section). Contact supplier if issues arise.
10. Only use REO-MECH approved spare parts and accessories with machine.
11. Do not bend short lengths.
12. Keep away from sparks and naked flames.
13. Always check power cord for damage and safe placement prior to use.
14. Disconnect bender from power outlet when not in use.
15. Inspect bender before each use (refer to Maintenance section). Do not use when quality has
been compromised.
16. Do not cover air vents on machine.
17. Store out of reach of children.
2. Specifications & Parts
Power Supply:
Ensure machine is connected to correct power supply (check machine label to confirm power
supply).
Extension Leads:
Where possible, connect machine directly to power outlet. If an extension lead is required,
ensure lead is under 35m in length. Minimum extension lead diameter are prescribed below:
Extension Lead
Length (m)
Min Wire ø (mm²)
25m
1.0
35m
1.5
